How Are Rife Manufacturers Compared?

[Richard Di Nucci]

Char:

Thanks for your suggestions (As a side note, I've done quite a bit of reading here on the RifeForum over the past 6 weeks, and every time I see your name on a thread, I have always found very useful and practical information!!!). So needless to say, I was pleased to see your addition on this thread.

Yes, we desperately need an updated Rife Machine Table, and I agree with your suggestions to make it a lot more easily readable. I had glanced at that Wiki table a few weeks ago, and asked myself if non-technical people would be better served by modifying the Wiki table to conform, to a greater degree, with many of the categories that Peter Walker had identified in the beginning of this thread (wow! that was waay back in 2002!). I also resonate (no pun intended!) with much of the process that Peter had identified back then.

But this undertaking, while a challenge, must be done; it could be made easier to do if we can somehow minimize the politics and unsubstantiated info from folks who represent some of the manufacturers. I'm just a newcomer to this Forum, but I'll do what I can to contribute.

To All: Please feel free to provide your thoughts, as well as constructive criticisms with the current Wiki format that I've referenced above.

R
<img id="ums_img_tooltip" class="UMSRatingIcon">

[Peter Walker]

I am planning to take up that project again soon, probably in March. Just a matter of finding the time to do it.

There are a number of articles I am planning to release on the wiki including device related ones.

[Richard Di Nucci]

Peter:

Members of this Forum are grateful for your continued hard work and dedication.

With all that you do, it's a wonder that you find time for stuff like this. Please reach out to us if we can be of help, even in doing some mundane tasks. I'll be happy to help out in whatever way I can.

R
<img id="ums_img_tooltip" class="UMSRatingIcon">

[Mike J Bell]

Its nice to see some life on this forum I was about to give up due to the older posts. I have only owned an Ultimate B3 Frequency Generator it is a 2.4 MHZ Sweep Function Generator. It is currently over 10 yrs old, I do not know how it stacks up to all the latest machines on the market. In fact I am lost as to what I could upgrade to that compares. Also is there anything out there that would fight infections etc thats affordable for someone on a tight budget? Thanks for any help.

[Jenny Lin]

Q1) Besides Perl from ResonantLight & RobinF125 & other Robin models, can GB4000 and Doug Coil run frequencies with more than 1 decimal point, such as 705.86, 56.56, etc.?

Q2) Also, what are the frequency range limitations of all these machine? What are the highest and lowest frequecy they can run?
(A) Perl;
(B) RobinF125;
(C) GB4000 with or without plasma light;
(D) Doug Coil

Q3) I also heard that if a machine can't run a certain frequency, we can divide or multiple it by 2 until it reaches a frequency number one's machine can run. For example, if a machine can't run freq. 5.5, we can multiple it by 2, then by 2 by 2 to reach freq. 44 so that that particular rife machine which can only run freq. over 40 can run it. Has anyone had any postive and/or negative experience on this? Please share and/or give your 2 cents. Thanks.

Jen

[Travis Rich]

they may run .23 for example but what is the range of accuracy for the frequency generated?